Butterfly Valves • Resilient Seated |
|
|
|
|
|
|
 |
Spec Sheet for Figure 711 |
|
 |
Installation/Operation Manual |
|
|
|
|
Drawings for Figure 711 — 10"-12" Wafer Butterfly Valve - Standard Configuration |
|
 |
|
|
|
|
|
Drawings for Figure 711 — 14"-24" Wafer Butterfly Valve - Standard Configuration |
|
 |
|
|
|
|
|
Drawings for Figure 711 — 2"-8" Wafer Butterfly Valve - BUNA-N Seat |
|
 |
*Autodesk's Revit or comparable software required to open RFA files
|
|
|
|
|
Drawings for Figure 711 — 2"-8" Wafer Butterfly Valve - BUNA-N Seat, Gear Operator |
|
 |
*Autodesk's Revit or comparable software required to open RFA files
|
|
|
|
|
Drawings for Figure 711 — 2"-8" Wafer Butterfly Valve - EPDM Seat |
|
 |
*Autodesk's Revit or comparable software required to open RFA files
|
|
|
|
|
Drawings for Figure 711 — 2"-8" Wafer Butterfly Valve - EPDM Seat, Gear Operator |
|
 |
*Autodesk's Revit or comparable software required to open RFA files
|
|
|
|
|
Drawings for Figure 711 — 2"-8" Wafer Butterfly Valve - Standard Configuration |
|
 |
|
|
|
|
Always verify that you have the most recent product specifications or other documentation prior to the installation of these products. |
BACK |
|
|
FNW cartridge style resilient seated butterfly valves are designed to meet the rigorous requirements of industrial applications such as pulp and paper, water purification, power and utilities, chemical/petrochemical, food and beverage, OEM and HVAC. Each valve is manufactured in accordance with independent standards specifications and is 100% tested in both directions of operation to assure bubble-tight service for many years.
| Standard Features: |
- Designed for 125/150 lbs flanges
- Standard aluminum-bronze disc
- Mounting pad with square shaft permits direct mount actuation that reduces hysteresis and cost (2" to 12")
- Secured stem retainer plate for blowout-proof protection and also allows operator removal with valve in line
- High strength two-piece stem eliminates taper pins and disc screws from flow path
- Rated to 200 PSI (2"-12"), 150 PSI (14"-24")
- Cartridge style seat permits easy change without special tools
- Molded o-ring eliminates the need for flange gasket
- Shell tested to 150% and seat tested to 110% of maximum working pressure
- Dual PTFE shaft bearings for reduced torque and improved stem alignment
- Vacuum rated to 29.9496"HG (0.01 Torr)+
- Epoxy coated body
- Low maintenance design
+Vacuum measurements are often made in inches of mercury below atmospheric pressure. The values
calculated here assume standard atmospheric pressure of 29.92 inches of mercury. |
|
|
|
|